My screen is unlocked and shows the desktop of apps. Everything goes as you say until you say aa message will pop up on the Android with an RSA fingerprint and asking for permission to access that device. I give it the ADB DEVICES command in a command prompt window running with Administrator privileges. It gets to the point of deciding which drivers it needs to install on my Win 10 PC and then it installs them. 1.3 that had the largest number of downloads. I’ve gone through all your steps with both the latest (1.4.3?) 15-second installer and the older v. It took me hours of tilting the screen sideways and upside-down to finally get it into Developer Mode and then turn on USB Debugging on the UMI while i’m waiting for a replacement to arrive from Hong Kong since nobody here seemed to have them. I’ve been trying to use ADB to control an attached UMI Plus E (6.01 maybe) with a cracked screen. Now you have successfully set up your Android device to Allow USB Debugging and authorized it to receive ADB Commands from your computer. Once the above step is complete, you should see your device is listed in the command prompt.Tap on ‘Always allow from this computer’ and press OK. Once you run the above command, you should now get a prompt on your Android device asking if you want to allow USB Debugging.Run the following command in the command prompt or PowerShell window:.Make sure the device is unlocked and the screen is lit.Connect your Android device to your computer.To do this: Hold down Shift Key and Right-click on the empty space inside the folder and then select ‘ Open command window here‘ or ‘ Open PowerShell window here‘. Open a command prompt from inside this folder.Go to the folder where ADB and Fastboot drivers are installed on your computer.Once you have installed the necessary ADB and Fastboot drivers, follow the below steps: SEE ALSO How to Change DPI Density on Android
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |